AUTOTECH CONTROLS M1030-E overview
Autotech M1030-E Programmable Load Monitor, Mini*PLM Programmable Load Monitor, Mini-PLM M1030-E from Autotech, is one of the best investments in tools for a press. It offers an economical entry into the Press Load Monitoring. While the Ml 030-E pays for itself very quickly by protecting the press &...
Manufactured byAUTOTECH CONTROLS
Part number or familyM1030-E
Product groupProgrammable Load Monitors
What is AUTOTECH CONTROLS M1030-E?
Autotech M1030-E Programmable Load Monitor, Mini*PLM Programmable Load Monitor, Mini-PLM M1030-E from Autotech, is one of the best investments in tools for a press. It offers an economical entry into the Press Load Monitoring. While the Ml 030-E pays for itself very quickly by protecting the press &...
Product details
Manufactured byAUTOTECH CONTROLS
Product groupProgrammable Load Monitors
DescriptionAutotech M1030-E Programmable Load Monitor, Mini*PLM
OverviewProgrammable Load Monitor, Mini-PLM M1030-E from Autotech, is one of the best investments in tools for a press. It offers an economical entry into the Press Load Monitoring. While the Ml 030-E pays for itself very quickly by protecting the press & dies, your investment in MI 030-E is protected. If in the future you require Full Load Signature Analysis capabilities, you can upgrade to our Signature Analysis model M1030, by paying only the difference in the cost (within 3 years of purchase),The Low Cost Mini•PLIvl M1030-E measures Load or Tonnage on a press by using strain gages mounted on load bearing members, such as press columns_ The M1030-E compares the measured load against user programmed limits for Press Protection. Die Protection and for Process Trend.If the measured Load is outside the programmed limits, the M in i-PLM de-energizes the appropriate fail-safe relay, that can be used to stop the press, warn the operator, and'or signal a supervisory control.The Min i-PL M uses strain gauge sensor with built-in ampliifer for tonnage measurement. The sensors provide current signals proportional to tonnage. This makes wiring of sensors very easy. The user does not have to worry about length of wires, or splicing of wires.The Mini-111,M has two counters for counting total number of hits. as well as the number of good parts made. A part is considered good if it did not cause any alarm or fault during stamping.
Key FeaturesUp to 4 sensors in one small panel mount 7.25" x 53" x 5.9" package. Tonnage sensors with 4-20 mA output to simplify wiring. Built-in sensor integrity check detects broken sensor wires as well as unusual sensor drift. Total number of hits and °A of good for SPC. Programmable Over & Under Limits for Press Protection, Die Protection & Process Trend. Die & Process Trend Limits programmable in tons or in percentage. Learn Mode to automatically compute reference tonnage for Die Protect Band. Process Trend Base is the running average of tonnage measured over programmed number of preceding cycles. Limit comparisons can selectively be disabled (except Press Overload Limit). 4 Fail-safe alarm outputs. Separate outputs for Positive & Negative Press Tonnage Limits. Separate outputs for Over & Under Tonnage. Field replaceable electromechanical relays for alarm outputs. Multiple setup storage allows quick limit changeover.
Manufacturer, product group, and supply
See who makes this product, where it belongs, and where available inventory may be listed.
Manufactured by
AUTOTECH CONTROLS
View AUTOTECH CONTROLS profile
Product group
Programmable Load Monitors
Explore Programmable Load Monitors
Available from
Sourcing support available
Start a sourcing request